There are lots of Taiwan PCB fabricators using tin/lead for Tin/lead PCB surface finish while there are PCBA manufacturers using tin/lead solder pastes ________________________________ From: Lehmicke, Michael <[log in to unmask]> Date: 8 December 2016 at 10:59:06 PM SGT To: [log in to unmask] <[log in to unmask]> Subject: [TN] Tin Lead chemistry in Asia Good morning; Are PCB assembly companies in Taiwan allowed to use Tin Lead chemistry at all? (either Wave solder, paste, or 63/37 solder wire) Thanks, Mike Lehmicke Project Engineer DSS Division Molex, LLC-Printed Circuit Solutions 22 Empire Drive St. Paul, MN 55103 651-846-7728 [log in to unmask]<mailto:[log in to unmask]> [cid:[log in to unmask]][cid:[log in to unmask]]<https://urldefense.proofpoint.com/v2/url?u=http-3A__www.molex.com_&d=CwIFAg&c=nvOEfClv88r3To4eOyYtQN0213v_-JGWbujap2hCee4&r=-MAMt3MrjiRvYJiwVeFoas7eghr5IF6QpUBreyGR1qs&m=mj9g0n1KhFXxHDjMwbZl89BWOGiIhCnLXYbRghCC2eY&s=1a_XwqPk1IvdarNNZYA32ATph-K68ayPaVyIiurXF3w&e= > ________________________________ CONFIDENTIALITY NOTICE: This message (including any attachments) may contain Molex confidential information, protected by law. If this message is confidential, forwarding it to individuals, other than those with a need to know, without the permission of the sender, is prohibited. This message is also intended for a specific individual. If you are not the intended recipient, you should delete this message and are hereby notified that any disclosure, copying, or distribution of this message or taking of any action based upon it, is strictly prohibited. English | Chinese | Japanese https://urldefense.proofpoint.com/v2/url?u=http-3A__www.molex.com_confidentiality.html&d=CwIFAg&c=nvOEfClv88r3To4eOyYtQN0213v_-JGWbujap2hCee4&r=-MAMt3MrjiRvYJiwVeFoas7eghr5IF6QpUBreyGR1qs&m=mj9g0n1KhFXxHDjMwbZl89BWOGiIhCnLXYbRghCC2eY&s=yoH57-hVDwNw_pDdGFQOFSOzFyxgN6uA1-0IlRalQQM&e=