Subject: | |
From: | |
Reply To: | |
Date: | Mon, 25 Jan 2016 19:45:21 +0000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Vlad,
Does IPC or any other Industry Standard/bench mark have specs. on PFP?
Victor,
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Vladimir
Sent: Monday, January 25, 2016 12:43 PM
To: [log in to unmask]
Subject: Re: [TN] Press Fit Pins guideline
You'd have to section them. We have a special spec from one of our customersı outlining all requirements.
Regards
ıVladimir
SENTEC
Sent from my BlackBerry 10 smartphone on the Rogers network.
Original Message
From: Victor Hernandez
Sent: Monday, January 25, 2016 13:40
To: [log in to unmask]
Reply To: TechNet E-Mail Forum
Subject: [TN] Press Fit Pins guideline
Fellow TechNetters:
What is the current IPC guideline/specification for insertion depth of Press Fit Pins. I aware that the Press Fit Pins configuration might vary a little, just as well as board thickness. What is the acceptance criteria I should look for visually and during x-ray imaging.
Victor,
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|