Vlad, Does IPC or any other Industry Standard/bench mark have specs. on PFP? Victor, -----Original Message----- From: TechNet [mailto:[log in to unmask]] On Behalf Of Vladimir Sent: Monday, January 25, 2016 12:43 PM To: [log in to unmask] Subject: Re: [TN] Press Fit Pins guideline You'd have to section them. We have a special spec from one of our customersı outlining all requirements. Regards ıVladimir SENTEC Sent from my BlackBerry 10 smartphone on the Rogers network. Original Message From: Victor Hernandez Sent: Monday, January 25, 2016 13:40 To: [log in to unmask] Reply To: TechNet E-Mail Forum Subject: [TN] Press Fit Pins guideline Fellow TechNetters: What is the current IPC guideline/specification for insertion depth of Press Fit Pins. I aware that the Press Fit Pins configuration might vary a little, just as well as board thickness. What is the acceptance criteria I should look for visually and during x-ray imaging. Victor, ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________ ______________________________________________________________________ This email has been scanned by the Symantec Email Security.cloud service. For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________