That would be in the component drawing from the vendor.
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Victor Hernandez
Sent: Monday, November 09, 2015 12:51 PM
To: [log in to unmask]
Subject: [TN] IPC SMT Lead to package co-planarity
Fellow TechNetters:
In which IPC STD will I find information of distance between the plastic housing standoff and lead height. INMHO the standoff should rest on the solder mask surface while the lead should have a slight gap to rest on the PWB copper pads. I hope that this makes sense. A print/spec is not readily available.
Victor,
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________