Subject: | |
From: | |
Reply To: | |
Date: | Tue, 5 Aug 2014 16:43:52 +0200 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Victor,
You can also refer to IPC A-610E par. 7.3.5.9 pag. 7-53.
Francesco
Francesco Di Maio
IPC A-600, IPC A-610, IPC 7711/21 Certified IPC Trainer
"Gumpert, Ben" <[log in to unmask]>
Sent by: TechNet <[log in to unmask]>
05/08/2014 15.56
Please respond to
TechNet E-Mail Forum <[log in to unmask]>; Please respond to
"Gumpert, Ben" <[log in to unmask]>
To
<[log in to unmask]>
cc
Subject
Re: [TN] Post solder Component lead trimming
Victor,
J-STD-001 Rev E Para. 6.1.4 states that leads trimmed shall have the
solder reflowed or inspected at 10X for damage.
And if the trim cuts into the solder fillet, it must be reflowed.
Ben
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Victor Hernandez
Sent: Tuesday, August 05, 2014 9:33 AM
To: [log in to unmask]
Subject: EXTERNAL: [TN] Post solder Component lead trimming
Fellow TechNetters:
Does IPC Standards address the lead trimming of components on post
solder assemblies. I heard that on post solder lead trimming that a
second pass solder operation is required to ensure solder joint integrity
from the lead trimming process. Any comments and/or direction for
literature review.
Victor,
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|