Ioan,

How do you succeed gettig solder SPLASHES with hand soldering??? I have
seen most about soldering but not that  Can you give us a photo? I suspect
it's not the solder wire's fault, mais quelque chose á la carte ou d'une
 procès fausse.

Inge

On 8 February 2013 20:28, Ioan Tempea <[log in to unmask]> wrote:

> Dear Technos,
>
> What do you think about this? Sounds pompous, but I wonder if this
> existed...
>
> We noticed many solder balls and splashes on a particular board, after
> manual soldering or repairs/touch-ups and I wonder if there would be a
> particular brand/model of solder wire which is less splash prone.
>
> Thanks,
>
> Ioan Tempea, ing.
> Ingénieur principal de fabrication / Senior Manufacturing Engineer
> [signature002]<http://www.digico.cc/>
>
> 950 RUE BERGAR, LAVAL, QC, H7L 5A1<http://g.co/maps/2gh3f>
> T+ 1 (450) 967-7100, EXT244
> ------------------------------------------------------------------------
>   [signature001] <http://www.facebook.com/pages/Digico/277076778479>
> ------------------------------------------------------------------------
> Lauréat Dunamis 2012<http://digico.cc/dunamis-2012/>
> Entreprise manufacturière / Gestion du capital humain
>
>
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud service.
> For more information please contact helpdesk at x2960 or [log in to unmask]
> ______________________________________________________________________
>

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________