Brian,
Thanks for sharing your comments. I would like some sort of official standard are document stated the permissible plating scheme for press fit connectors. As others have stated that the hole drill size is critical. I have also notice different designs of press fit pins eyelids and at different depth with regards to the shank length. I have measured the Ni thickness on several different vendor connector and all with different thickness. One print di confirm tin over plated with nickel but not thickness criteria.
Victor,
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Brian Chandler
Sent: Friday, June 29, 2012 6:58 AM
To: [log in to unmask]
Subject: Re: [TN] Press Fit Pins on ENIG raw board
I would expect the retention force to be low with the Ni to Ni interface along with the cracking issue previously mentioned.
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________