Subject: | |
From: | |
Reply To: | |
Date: | Thu, 30 Jul 2009 14:20:59 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Upton
I presented a paper at IPC and published it in PC Fab several years ago which analytically defined the parameters involved in plating through holes. There are several parameters controlling difficulty of plating; the D/AR is one such parameter. In this case it varies with the second power. There are others of equal importance. Before attempting this design you may want to review this paper and decide if the degree of difficulty is acceptable.
Best regards
Lee
J. L. Parker Ph. D.
JLP Consultants LLC
804 779 3389
----- Original Message -----
From: Upton, Shawn<mailto:[log in to unmask]>
To: [log in to unmask]<mailto:[log in to unmask]>
Sent: Thursday, July 30, 2009 10:05 AM
Subject: [TN] Via plating question
Quick question: I usually have via's plated to a minimum of 1mil. I
have a high current design where I'd like to have those via's plated to
2mil (near 2oz, to match the 2oz spec for the layers) -- but the board
has some 15mil vias and is a 125mil thick board. Would a typical board
house be ok with this? I don't care about getting those 15mil mil
diameter via's to 2mil barrel plating, only the 32mil ones need to be
that thick.
Shawn Upton, KB1CKT
Test Engineer
Allegro MicroSystems, Inc
[log in to unmask]<mailto:[log in to unmask]>
603.626.2429/fax: 603.641.5336
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask]<mailto:[log in to unmask]> with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]<mailto:[log in to unmask]>: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]<mailto:[log in to unmask]>: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives<http://listserv.ipc.org/archives>
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16<http://www.ipc.org/contentpage.asp?Pageid=4.3.16> for additional information, or contact Keach Sasamori at [log in to unmask]<mailto:[log in to unmask]> or 847-615-7100 ext.2815
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|