Subject: | |
From: | |
Reply To: | |
Date: | Fri, 17 Nov 2006 18:55:49 +0300 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
If the pad comes off it is because there is a crack between the pad and the
base material, and no conductor is there to prevent it from coming off. I
would suspect that if you do a cross section of active pads in the same area
you have a fair chance to see such cracks unde the pads, and even lifted
pads.
You intend to replace the BGA on this area. Are you sure that the new
connections will be as good as new?
Gaby
----- Original Message -----
From: "bob wettermann" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Friday, November 17, 2006 6:10 PM
Subject: [TN] One solder Ball Not Connected on a No Connect Pad After Rework
> This question to the group is about expected solder joint strength on a
> BGA.
>
> The BGA in question is a 8 x 8mm plastic package BGA using a LF SAC305
> soldering process. It has 64 x 0.018" balls holding it to the PCB.
>
> When removing this device for rework 3-4% of the time one of the corner
> NO CONNECT pads comes off.
>
> The question is if we do nothing upon replacement of a new device to
> the damaged pad will it really make a difference ??? We are arguing that
> the holding strength of the reworked device would be approximately the
> same because the change in overall surface area is marginally impacted.
>
>
> Thanks
>
> Bob Wettermann
>
>
> Bob Wettermann
>
> ---------------------------------------------------
> Technet Mail List provided as a service by IPC using LISTSERV 1.8e
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt or (re-start) delivery of Technet send e-mail to
> [log in to unmask]: SET Technet NOMAIL or (MAIL)
> To receive ONE mailing per day of all the posts: send e-mail to
> [log in to unmask]: SET Technet Digest
> Search the archives of previous posts at: http://listserv.ipc.org/archives
> Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
> for additional information, or contact Keach Sasamori at [log in to unmask] or
> 847-615-7100 ext.2815
> -----------------------------------------------------
> PH 847-767-5745
>
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|