J-STD-001C Class 3 requirements might be sufficient. Appendix B of
J-STD-001C might be the trick.

> -----Original Message-----
> From: TechNet [mailto:[log in to unmask]] On Behalf Of Ken Patel
> Sent: Thursday, January 15, 2004 1:23 PM
> To: [log in to unmask]
> Subject: [TN] No Clean solder paste note for
> Telecom/Networking products
>
>
> Experts,
>
> If I have to allow my CM to use No Clean solder paste, what
> kind of note should I put on assembly drawing (with some kind
> of qualification requirement)? Our product is for
> telecom/networking industry so I rather specify some kind of
> qualification requirements (if any) than just write - use no
> clean solder paste. I know all pastes are not same and may
> not be suitable for certain industry.
>
>
>
> I used to put a note on my assembly drawing for hand
> soldering something like...
>
>
>
> HAND SOLDER FOLLOWING COMPONENTS USING TELCORDIA (BELCORE)
> COMPLIANT NO-CLEAN FLUX.
>
>
>
> Any help will be appreciated. Thanking you in advance.
>
>
>
> Re,
>
> Ken Patel
>

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------