Hi all,

I've been involved in several rigid-flex designs recently. Our
manufacturing notes on the fabrication
drawing have specified "Manufacture board in accordance with
MIL-PRF-31032/4, Class A".

Now a decision has been made to change the above mentioned line to an IPC
specification. However
IPC does not seem to have a specification that covers rigid-flex boards the
way 31032 does. I really
could use some advice on this. Niether IPC-6012 or IPC-6013 really seem to
fit the need in this case.

Any suggestions will be greatly appreciated,
************************************
          Paul Fly   CID+

Eastman Kodak Company
Engineering Technology Center - EEC
2nd Fl.  Bld. 205  K.P.
2400 Mt. Read Blvd.
Rochester, New York 14650-3007
Phone: (585) 726-5670
Fax: (585) 726-0275
E-mail: [log in to unmask]
************************************

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------