hi,

i don't know if you got what you wanted.  if not, here are two references for you.  one gives you bend deductions for steel and aluminum sheet.  the second reference derives bend deductions from k-factors.

hope this helps.

phil

http://www.lehisheetmetal.com/1_e_bend.htm

http://www.massey.ac.nz/~odiegel/bendworks/bending.pdf





-----Original Message-----
From: Hinners Hans M Civ WRALC/LUGE [mailto:[log in to unmask]]
Sent: Friday, January 10, 2003 7:44 AM
To: [log in to unmask]
Subject: [TN] OT - Bending Al Sheet Spec (was Re: [TN] Spray Paint
Application Specs)


Wow!

Once again I'm amazed at the wealth of knowledge on the list.
Especially when I can use that painting spec on some new drawings.

I'd like to find a spec (mil or industry) for bending Al sheet - general
process guidelines and inspection.  I've got an Air Force Tech Manual but
citing those on drawings is frowned upon.

Hans

You can run . . .  but you'll only die tired.
~~~~~~~~~~~~~~~~~~~~~~~~~~~
Hans M. Hinners
Warner Robins Air Logistics Center (WR-ALC)
226 Cochran Street
Robins AFB, GA 31098-1622
Tele: (478) 926 - 5847 [DSN Prefix: 468]
Fax: (478) 926 - 4911
mailto:[log in to unmask]

---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------

---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------