Advice please. We have had a problem here we have cut in the solder fillet
while trimming leads (pretty deeply, we have also seen cracked solder
fillets) which is a violation of IPC. There are several hundred of these
asm. I suggested to Re-run them through wave. Has anyone else had to do
this and what have the results been, this sure beats touch-up on every
lead. I am not re-fluxing the asm, we spray no-clean and some gets on the
top the 1st time around which is acceptable, but 2nd time it is just to
much. Anyone have any comments? Any help would be great.
Dave
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------