Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Mon, 15 Jan 2001 07:26:22 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Good Morning Dave
Per IPC-A-600F page 11 is Acceptable Class 1,2,3, spacing between conductors meets minimum conductor spacing requirement.
Per IPC-A-610C Page 10-8 Acceptable Class 1,2,3, the weave does not reduce the spacing between conductive patterns.
Weave Exposure is Acceptable. for Class 1,2,3, Just watch your conductive spacing you can find a Table in IPC 610C on page A-1. If you violate the clearance then it is a defect.
Have a good day.
Nancy T.
>>> [log in to unmask] 01/12/01 02:29PM >>>
I have a customer for a high rel application that is concerned about weave exposure on a epoxy glass stiffener.
According to IPC-610, weave exposure is not acceptable. Our material supplier sands the material in order to meet tight thickness tolerances. Per IPC-6013, stiffeners are to be evaluated only for mechanical support. In addition, the circuit as supplied is allowed weave exposure if conductor spacing is not reduced below minimum. Since a stiffener carries no conductors, I would consider this a non-issue.
Any words of wisdom from manufacturers or assemblers welcome.
Dave Kell
Minco Products, Inc.
======================================PLEASE NOTE: Our area code has changed
from 612 to 763.
======================================
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|