Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 9 May 2000 10:12:46 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Good Morning/Afternoon TechNetters!
Those of you using 0201 and 0402 technology, what typical spacing between
pads are you using? Has anyone performed a DOE or Taguchi Robust Design on
these type components to find out where tombstoning starts or placement
problems or paste application problems?
I have been searching web sites and have found little on these type
subjects. I was on the TechNet a couple weeks ago and received some great
advice on 0201 and 0402 subject matter, but really I didn't ask any detailed
questions. Is this portion of SMT technology still that new? Any and all
comments are welcome.
Thanks
Ron Hollandsworth
ITT
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|