Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 17 Mar 2000 12:27:50 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi everyone, I am confused! I am preparing to teach a 610 class (rev. B) and I came across a problem dealing with wire wraps.
Just below figure 3-49 on page 40, item B states that "minimum wrap for round posts has less than 180 degrees of contact between the wires and the terminal". This is listed as acceptable for class 1 and 2. However, under figure 3-52 on page 41 it
states minimum wrap contacts the terminal 180 degrees, or 90 degrees (if mechanically secured).
My question is; is it acceptable for class 2 to have a wrap less than 180 degrees on a round post or not? Thanks in advance for your help!
Tim DeVaul
Total Quality Training and Audit Supervisor
Philips Broadband Networks, Inc.
100 Fairgrounds Dr.
Manlius, New York 13104
Tel: (315) 682-9105 Ext. 2403
Fax: (315)682-9006
Email: [log in to unmask]
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|