Dear Hao,
 
可以考虑以下做法:
 
1) 将F-CONNECTOR的PIN 改成带直角的.
2) 或着改通孔焊接为直接表面焊接,改PCB板的焊盘.
 
像你们这样弯曲后再焊接,PIN 针会受到应力,似乎欠妥.
 
 
B/R
 
Charles Lee


  _____  

From: TGAsia [mailto:[log in to unmask]] On Behalf Of [log in to unmask]
Sent: Thursday, January 13, 2011 5:10 PM
To: [log in to unmask]
Subject: Re: [TGAsia] F头装配


弯曲时插孔内的部分受力了吧  单从图片上看不出具体尺寸的大小，建议你想办法使得
在弯曲尾针的时候，避免F头内部分的芯针受力就可以彻底解决了
   见过带座二极管吧   可参考其原理、结构！
   我的一点拙见！
 
       岳会昌
2011-01-13 
  _____  

  _____  

发件人： 郝兆兵 
发送时间： 2011-01-13  16:41:51 
收件人： TGAsia 
抄送： 
主题： [TGAsia] F头装配 
各位好：
 
 
有没有好的方法，避免此现象的发生。谢谢
2011-01-13 
  _____  


______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________


______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________


______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please contact helpdesk at x2960 or [log in to unmask] 
______________________________________________________________________