 
| Sender: |
|
| X-To: |
|
| Date: |
Tue, 27 Feb 2018 22:52:59 +0000 |
| Reply-To: |
|
| Message-ID: |
|
| Subject: |
|
| From: |
|
| MIME-Version: |
1.0 |
| In-Reply-To: |
|
| Content-Transfer-Encoding: |
base64 |
| Content-Type: |
text/plain; charset="utf-8" |
| Parts/Attachments: |
|
|
Larry,
Just a good natured jab.
If you do it, Rout the board with unused pads present. Run your design checking software including the drill file. Then remove the unused pads.
Regarding the reliability, I’ve seen studies that go either way. Situation dependent.
Where’s Bill Birch when we need him. :)
Brs,
Gerry
> On Feb 27, 2018, at 4:26 PM, Larry <[log in to unmask]> wrote:
>
> Gerry/Joyce,
>
> it is a last resort for me, hopefully I will not need to do it.
>
> Thanks everyone for all the advice, much appreciated as usual,
>
> Larry
|
|
|
