Sender: |
|
Subject: |
|
From: |
|
Date: |
Wed, 28 Oct 1998 14:46:51 -0500 |
X-To: |
|
Reply-To: |
|
Parts/Attachments: |
|
|
Hi Ken. Motorola has done extensive studies picking up where IBM left off.
I strongly recommend that you contact your local Mot distributer and get
Mot's BGA PCB packaging/layout design guidelines. They claim that on a PBGA
(plastic) one should use a soldermask defined pad. That would be a
soldermask opening smaller than the actual pad diameter. On a .050 pitch
grid array, for example, they state to use ONLY a .023 opening on a pad of
approximatley .030. For ceramics and columns it's a diferent configuration
completely. But - get the specs from Motarola. They appear to have the
answers based on extensive studies they've done. Regards, Russ Steiner
Controls/inc. Good luck/best wishes.
-----Original Message-----
From: Ken Patel <[log in to unmask]>
To: [log in to unmask] <[log in to unmask]>
Date: Tuesday, October 27, 1998 3:04 PM
Subject: [TN] Hot: Trace width and air gap for 1mm pitch BGA
>BGA Design/process Guru,
>We are designing board with 1mm (39.37 mils) pitch 672 pin BGA. I have the
>following questions which I need urgently.
>
>(1) What is the recommended pad size?
>(2) What the recommended via size?
>(3) What will be the trace width and air gap if I need to pass 2 traces? We
>are limited in number layers so we want to go for double traces instead of
>single trace between the pads.
>
>re,
>Ken Patel
>______________________________________________________
>Ken Patel Phone: (408) 490-6804
>1708 McCarthy Blvd. Fax: (408) 490-6859
>Milpitas, CA 95035 Beeper: (888) 769-1808
>
>################################################################
>TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
>################################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
>To subscribe: SUBSCRIBE TechNet <your full name>
>To unsubscribe: SIGNOFF TechNet
>################################################################
>Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section
for additional information.
>For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
>################################################################
>
>
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|