Subject: | |
From: | |
Date: | Fri, 07 Feb 97 09:01:38 MST |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
To what extent?
Both internal and external?
______________________________ Reply Separator _________________________________
Subject: FAB: Annular Ring
Author: [log in to unmask] at INTERNET
Date: 02/07/97 3:54
Subject: Re: Annular Ring
In-Reply-To: your message of Tue Feb 04 18:00:23 -0500 1997
Content-Type: Text
To: [log in to unmask]
My vote is to allow breakout.
I have been working with an ITRI committee that is in the process of
completing a reliability study of breakout. A report will be issued sometime
in the next few months. To date, this study has found no evidence for a
reliability risk from breakout. Further evidence for accepting breakout comes
from the specifications of many large OEM's who have allowed breakout for
years with no reported reliability problems.
Bob Holmes PHD
804-226-5114
[log in to unmask]
After April 1
804-737-4987
[log in to unmask]
------------- Begin Original Message -------------
From: ipc.ipc.org!TechNet-request
Date: Tue Feb 04 18:00:23 -0500 1997
Subject: Annular Ring
Original-CC: [log in to unmask]
To: [log in to unmask] (!technet)
Cc: [log in to unmask]
Content-Type: text
Content-Length: 1258
Dear fellow designers,
we are in process of revising our corporate specs,
so we can achieve bigger board density.
Our present requirements are (external and internal) 0.002 inch annular
ring, except in the area adjoining the conductive trace where there
shall be 0.005 minimum annular ring.
Are there some data documenting defects or failure on boards using
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|