Subject: | |
From: | |
Date: | Tue, 14 May 96 11:09:03 CST |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
What is the solder mix - 60/40, 63/37?
______________________________ Reply Separator _________________________________
Subject: RE:ASSY:
Author: [log in to unmask] at internet-mail
Date: 5/14/96 9:36 AM
Dear Technet,
Whenever, I'm running a 100% through-hole board, that is densely populated
with mainly DIP components, and a only few capacitors and resistors., 20 to
30% of the solder joints are gritty.
It had never happened to board of mixed technology.
I have sent the solder for lab. analysis, and the result is within the
recommended specification.
The Board is :-
10 x 10 sq.inch
4 layers
The wave-solder Machine used :-
The wave-solder machine used is SEHO 2000 - a full-blown nitrogenous tunnel.
The solder pot temperature is set at 245 deg.cel or 473 deg.F.
The top side temperature is measured at about 194 deg.F / 90 deg.C.
Conveyor speed is set 0.90 metre/minute.
The solid content of the flux is 1%.
Could anybody advise me why this is happening, and how to solve it. Our
rework operators are touching every gritty joint.
Poh Kong Hui
Nera Electronics
|
|
|