Woops, I forgot to mention that we spray coat these boards. The bubbles are
most prevalent along thick edges but pretty much everywhere. I'll see if I
can get Steve to post a picture.
Thanks,
KennyB
-----Original Message-----
From: Kathy Kuhlow [mailto:[log in to unmask]]
Sent: Monday, June 02, 2008 9:53 AM
To: 'TechNet E-Mail Forum'; Ken Bloomquist
Subject: RE: [TN] Tiny Bubbles
Are the air bubbles along component edges or open areas? It might be that
you are moving the board in/out of the material too fast. I know from a
past project we needed to allow extra time during the dip prior to removal
for the air bubble to release on SOT package devices.
Kat
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------