Subject: | |
From: | |
Date: | Mon, 28 Jul 1997 16:57:55 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Steve,
LPI soldermask can sometimes bleed out (flow) a bit before it cures.
This yields a very thin coating of mask which may appear transparent
so that bright copper shines through, yet still performs its job and
resists solder during the HASL and assy processes. I haven't seen
this in several years so you may want to make sure that your board
supplier has their mask process under control.
Frank Hinojos
Watkins-Johnson Co.
______________________________ Reply Separator _________________________________
Subject: DES: Pads
Author: "Steve Collins" <[log in to unmask]> at INTERNET
Date: 7/24/97 1:35 PM
I have a .035 dia soldermask pad with no hole in a circular array pattern
that I use over our mounting holes so we can skip a spot mask process in
manufacturing. My question is : is this size pad too small to expose or
develop when using LPI soldermask . I have two vendor who are having
trouble with this pattern and when I get the boards in I have what looks
like exposed copper contained on some of the pads. We know that they are
not really exposed or else they would have covered in the HASL process or
would be discolored due to contamination. The pads are just as bright
copper color as you would expect to see before LPI soldermask is applied.
Anyone have any thoughts.
Steve Collins
PCB Design Supervisor
Antec
[log in to unmask]
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|