Mr. Bond told me that Goldfinger's hands have beveled edges.
I have never seen edge pads NOT beveled, except perhaps in the case of very thin PWBs, like .031" or less.
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of [log in to unmask]
Sent: Thursday, February 22, 2018 9:38 AM
To: [log in to unmask]
Subject: [TN] DIMM Modules Gold Finger Edge - Bevel/Coined/Chamfer
Dell - Internal Use - Confidential
Fellow TechNetters:
Is there an consensus out there whether the gold finger edge on DDR3 DIMM Modules be beveled/Coined/Chamfer. I would appreciate any comments/remarks on this topic.
Victor,
-----Original Message-----
From: Hernandez, Victor G
Sent: Wednesday, February 21, 2018 1:10 PM
To: TechNet <[log in to unmask]>
Cc: Hernandez, Victor G <[log in to unmask]>
Subject: FW: [TN] DIMM Modules Gold Finger Edge - Bevel/Coined/Chamfer
Fellow TechNetters:
Any additional comments and/or concern over the gold finger edge being Beveled/Coined/Chamfered. Many a times do I see socket with gold plated wire contact gouges from DIMM product that has not been beveled/Coined/Chamfered, even bent pins.
Victor,
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Jose A Rios
Sent: Wednesday, February 21, 2018 8:15 AM
To: [log in to unmask]<mailto:[log in to unmask]>
Subject: Re: [TN] DIMM Modules Gold Finger Edge - Bevel/Coined/Chamfer
I don’t know of a fully fledged std for it, other than workmanship acceptance criteria in 6012 and possibly mentions of design guidance in 2221
Sent from my iPhone
> On Feb 21, 2018, at 8:57 AM, "[log in to unmask]<mailto:[log in to unmask]>" <[log in to unmask]<mailto:[log in to unmask]>> wrote:
>
> Fellow TechNetters:
>
> Does IPC still have a STD for the above stated processt? If so, can someone direct me to the document.
>
> Victor,
|