TECHNET Archives

August 2002

TechNet@IPC.ORG
Options: Use Monospaced Font
Show HTML Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
Re: IPC Printed Board Dimension and Tolerances
From:
Gary Ferrari <[log in to unmask]>
Reply To:
TechNet E-Mail Forum.
Date:
Fri, 23 Aug 2002 08:29:29 EDT
Content-Type:
multipart/alternative
Parts/Attachments:
text/plain (1316 bytes) , text/html (1483 bytes) 
S L Ong,

The IPC -D-300 contains dimensioning and tolerance information including
appropriate tables. The information was intended for the designer to use
during the design phase. However, in 1990 the information contained in the
tables was updated and included in the then newly released IPC-D-275,
IPC-D-275 has since been replaced by IPC-2221/2222. The current IPC-2615
contains a much updated discussion on geometeric dimensioning an tolerancing
as applied to printed boards. It is referenced in IPC-2221/2222.

Regards,

Gary

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------

ATOM RSS1 RSS2