Julian:
Multiline makes a drill x-ray / optimizer that x-rays each panel and drills a
unique set of tooling holes based on the position of four inner-layer
targets.
This system has the advantage that it drills tooling holes that are specific
to each panel rather than choosing the best fit offset based on a small
sample of panels.
The company's address is
Multiline Technology
400 Broadhollow Rd.
Farmingdale, NY 11735
(516) 249-8300
Good Luck,
John Lennox
Process Engineer
EMC
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################