Subject: | |
From: | |
Reply To: | |
Date: | Wed, 24 Oct 2007 06:09:59 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Looking for any IPC standards or information concerning the removal of
excess board material left behind after depanelization, especially
breakaway/mouse bites? We have a situation where the left over material
causes the board dimensions to be out of tolerance, and was trying to
determine the best way to remove, and if there are any specific
standards we should adhere to.
Thanks,
Jim West
Engineering Manager
Nexergy Inc.
www.nexergy.com
tel: (614) 351-6216
fax: (614) 324-1979
This email message and all attachments transmitted with it are intended solely for the use of the addressee(s) and may contain legally privileged, protected or confidential information. If you believe that you have received this message in error, please notify the sender immediately by email reply and please delete this message from your computer and destroy any copies.
--------------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------
|
|
|