One thing to keep in mind here is that the Nordson style oven is made
especially for conformal coatings while the vitronics is not. The airflow
rates and other factors are much different for reflow than for conformal
coating curing. Our ovens fall into two classes:

One style for Reflow and curing (adhesives, solder mask, etc.)

One style for conformal coat curing.


>I have used a Nordson oven (ETS reflow oven) on 1753 (a thicker version of
>1765) successfully at a previous employer. Cure time was a minimum of 1
>minute (sometimes less) for 2 mil coating. This worked as long as relative
>humidity in the plant was over 25%. There was app. 30 seconds between end
>of spray and oven entrance sitting on a conveyor.
>-------------
>Original Text
>From: C=US/A=INTERNET/DDA=ID/TechNet(a)IPC.ORG, on 2/17/98 9:31 AM:
>See attached files.
>
>################################################################
>TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
>################################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
>To subscribe:   SUBSCRIBE TechNet <your full name>
>To unsubscribe:   SIGNOFF TechNet
>################################################################
>Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional
information.
>For the technical support contact Dmitriy Sklyar at [log in to unmask] or
847-509-9700 ext.311
>################################################################
>
>
>

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################