shawn,  try IPC-7721
----- Original Message -----
From: "Shawn Murphy" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, December 17, 2001 3:31 PM
Subject: [TN] Trace cut quality


> What specification would contain "Trace Cut" information?  We have a
> situation where there is obvious damage to the FR4 material between two
> leads that had a common trace at one point.  Our conscious tells us to
> repair the gouge but we haven't located anything in IPC-610 to tell us
what
> is acceptable and what isn't.  Any help would be greatly appreciated.
>
> regards,
> shawn
>
> --------------------------------------------------------------------------
-------
> Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
> To unsubscribe, send a message to [log in to unmask] with following text in
> the BODY (NOT the subject field): SIGNOFF Technet
> To temporarily halt delivery of Technet send the following message: SET
Technet NOMAIL
> Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
> Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
additional
> information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
> --------------------------------------------------------------------------
-------
>

---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------