shawn, try IPC-7721 ----- Original Message ----- From: "Shawn Murphy" <[log in to unmask]> To: <[log in to unmask]> Sent: Monday, December 17, 2001 3:31 PM Subject: [TN] Trace cut quality > What specification would contain "Trace Cut" information? We have a > situation where there is obvious damage to the FR4 material between two > leads that had a common trace at one point. Our conscious tells us to > repair the gouge but we haven't located anything in IPC-610 to tell us what > is acceptable and what isn't. Any help would be greatly appreciated. > > regards, > shawn > > -------------------------------------------------------------------------- ------- > Technet Mail List provided as a free service by IPC using LISTSERV 1.8d > To unsubscribe, send a message to [log in to unmask] with following text in > the BODY (NOT the subject field): SIGNOFF Technet > To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL > Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives > Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional > information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 > -------------------------------------------------------------------------- ------- > --------------------------------------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8d To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ---------------------------------------------------------------------------------