Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 28 Apr 1999 07:50:38 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
The vias are usually filled during the wave process. However, the board
house can fill them during manufacture of the board. 18 - 19 mils is a
standard size for vias. If they are to carry high current, perhaps
larger vias may be in order.
> -----Original Message-----
> From: Ken Patel [SMTP:[log in to unmask]]
> Sent: Wednesday, April 28, 1999 7:39 AM
> To: [log in to unmask]
> Subject: [TN] How to fill Vias? ...
>
> I am in dilemma. We have designed a board which require double reflow
> process with selective wave operation. Here is the problem - How can I
> get
> vias filled solder which will carry 1 amp current. Some vias are
> underneath
> the components and many are away from the selective wave fixture
> opening.
>
> Finished hole size of the via is 18 mils. Can fab house fill the vias?
>
> re,
> Ken Patel
> ______________________________________________________
> Ken Patel Phone: (408) 490-6804
> 1708 McCarthy Blvd. Fax: (408) 490-6859
> Milpitas, CA 95035 Beeper: (888) 769-1808
>
> ################################################################
> TechNet E-Mail Forum provided as a free service by IPC using LISTSERV
> 1.8c
> ################################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with
> following text in the body:
> To subscribe: SUBSCRIBE TechNet <your full name>
> To unsubscribe: SIGNOFF TechNet
> ################################################################
> Please visit IPC's web site (http://www.ipc.org) "On-Line Services"
> section for additional information.
> For technical support contact Hugo Scaramuzza at [log in to unmask] or
> 847-509-9700 ext.312
> ################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|