Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 19 Jul 2000 14:31:55 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
We swell the soldermask 1 mil over the pad geometry for 20 mil (19.685
mil)(.5mm) pitch QFP's, leaving just under 6 mils, (5.874mils) (.1492mm)
nominal, of soldermask between the pins... this helps to prevent bridging
between the pins... also we changed from using HASL to OSP for our boards
and the assembly house loves us. (For caps, resistors, etc....everything
else on the board, we swell the soldermask 4 mils. )
Protel's DFM rules make it possible to set these features down to the single
pad on the part...
- Bill Brooks
-----Original Message-----
From: Jorge A Rodriguez [mailto:[log in to unmask]]
Sent: Wednesday, July 19, 2000 1:07 PM
To: [log in to unmask]
Subject: [TN] Solder mask clearance
Fellow technetters,
Can someone help me to find out what's the maximum clearance
on all sides of pads for a HASL board on a 20 mil pitch QFP. We are having
bridging problems with this device and we are suspecting of the solder
mask between the pads. Currently the PWB we are using shows 10 mils pads
followed by a clearance of 2.5 mils and then 5 mils of solder mask. Also
what is a normal thickness of the plating on a HASL board?
Any information will be appreciated
Jorge A Rodriguez
Process Engineer
Conexant Systems Inc
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|