Sender: |
|
X-To: |
|
Date: |
Mon, 6 Oct 1997 14:15:30 -0400 |
Reply-To: |
|
Subject: |
|
From: |
|
In-Reply-To: |
|
Content-Type: |
TEXT/PLAIN; charset=US-ASCII |
MIME-Version: |
1.0 |
Parts/Attachments: |
|
|
Hi Josh,
The only benefit, from the info supplied, of using NaOH to maintain a high
pH would be if the water being used is recycled and the pH is considerably
low, or the water supply has a low pH.
I doubt whether there is any cost benefits with using NaOH, and
additionally the carbonate concentration should be about 1% for most if not
all dry film photo-resist developing; a solution within the 1% range
should maintain a sufficiently high pH for developing.
NaOH will tend to strip your exposed film and lead to opens in the
circuits.
You should consider using a proprietary developing solution that has a
buffering system.
Good Luck,
Lenny Kurup
On Sat, 4 Oct 1997 [log in to unmask] wrote:
> Recently, I heard of a dry film photoresist developer system that uses sodium
> hydroxide as a pH stabilizer. Apparently, the system doses the developer
> sump with carbonate based on a panel counter, and sodium hydroxide based on
> solution pH. The sodium hydroxide is used straight out of the drum, probably
> at around 40 % strength. I'm told this controls pH in a very tight range,
> and reduces consumption of carbonate.
>
> I have some questions regarding a system of this type.
>
> 1. What would the advantage be of using both chemicals? Cost savings don't
> seem to be too likely, since you are replacing one chemical with another.
>
> 2. What are the potential dangers of using sodium hydroxide in a developer?
> What effects could it have on photoresist?
>
> 3. Does the addition of sodium hydroxide cause bicarbonate to be converted
> to carbonate?
>
> 4. How many people are using this type of system in production?
>
> Thank you in advance for your assistance.
>
> ##############################################################
> TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
> ##############################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
> To subscribe: SUBSCRIBE TECHNET <your full name>
> To unsubscribe: SIGNOFF TECHNET
> ##############################################################
> Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
> For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
> ##############################################################
>
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################
|
|
|