Hi!
Could somebody comment on Hot Bar soldering methods?
-What are the requirements for coplanarity of leads?
-What are the PCB pads finish requirements?
- What flux to use and how to apply it (and clean it?) if the component
is resistant only to alcohols and deionized water, and not hermetic?
I wonder if Aric Parr's comment about not using no clean flux for touch
up is valid for Hot Bar too.
Thanks,
Gaby
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################