Hi all!
I would like to thank everyone who responding to my question about the
differences between RS-274 and RS-274-X. I've learned more about Gerber files
in the past twenty-four hours than I have in the five years since I started
working here. I approached my senior designer about this and he's wiling to
look into whether our board fabricators have the capabilities of reading this
format. I was able to show him how simple it was. The only snag we've found
was in the program we use in-house to mill prototype boards. It apparently
requires an apperture list. We may have to revert to RS-274-D for our
prototypes and use RS-274-X for the final release.
If anyone out there can help me with that little glitch, I'd surely appreciate
it. We use Isolator/Isolator for Windows version 3.2.3 by T-Tech Inc out of
Atlanta GA.
Many thanks!
JoAnn L. Amerson
Design Librarian
Red Lion Controls, Inc.
E-mail: [log in to unmask]
Voice: (717) 767-6961 ext 6308
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************