Hello Technet,
For stencilling 0.4 mm pitch patterns on a 30 * 20 cm board I think that a pad to pad tolerance of 0.0005 times the distance (which is the capability of our boardsupplier) is much too large to have accurate printing results.
What is a reasonable specification for pad to pad distance that good-quality board vendors should be capable to meet ?
Daan Terstegge
Signaal Communications
Unclassified
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################