Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 29 Jan 1999 06:23:33 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Greetings Techno's;
I am member of a No Clean Sterring Committee that is reviewing our
internal process that we are presently processed to perform, and
determine what is the best approach and what it would it take to
change over our lines to "NO CLEAN". The industry and our owners are
driving this change. The following are some questions I have and
wonder anyone out there that has experienced similar changes recently
a who would like to share their "Lessons Learned" with me. We are
building a mix technology, (i.e.; SMT only, SMT+thru hole, and thru
onle). Our products have various finishes, (i.e., potting and/or
conformal coat)
The following are some questions I have come across:
1) What is the best No Clean Flux that works well with organic coated
boards. We are looking at our suppliers using Entek CU-106A organic
coating?
2) Does the level of preheat that the organic coating is exposed to
detrimental to the shelf life of the coating? If so, what is the
amount of time period between IR reflow and wavesolder for a board
that has been exposed to IR reflow for SMT purposes? We are
experiencing poor solderability on the thru-hole components to the top
side of the circuit side.
3) Does the type of solder mask that is on the print wiring board
surface have any effects on the PPM level for solder balls? Does
anyone have any experience on this subject?
4) Does it hinder a companies purchasing power to narrow your
selection of types of solder mask? We presently have 8 different
solder mask finishes on our various products.
5) Does anyone out there have any experience on the Paste Inspection
system made by General Scanning? We recently brought a GC8200 in house
for evaluation. Initial data reflects that the measurement readings
obtained for CpK and Gage R&R are not acceptable. We used the
theoretical volume to calculate the mean and standard deviation. Is
this the accurate way of measurement? If someone out there that has
experience with this system that can help me, please respond.
I took up your time enough. Have a good day.
Thanks
Donn Steffen
Senior Quality Engineer
VDO Control Systems, Inc.
Auburn, IN
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|