Hi Nigel
If we were running a glued-on MSD part on the bottom side of a board and
then wave soldering it - I would be concerned with MSDs. Otherwise no
as the components are not seeing a high heat.
Similarly, doing hot air rework of a board I'm concerned with MSD parts
adjacent to the rework site, but not far away from it.
Graham Collins
Senior Process Engineer
Sunsel Systems
(902) 444-7867
On 4/9/2019 10:19 AM, Nigel Burtt wrote:
> Do I assume no-one has concerns about popcorn failures of MSDs during wave and selective?