Hi Mark!

Yes there is, and it's not only per job, but per panel in most cases. That's
why I asked the question...

There's a lot of "SHALL" requirements in the 6012 that have to be complied
with in order for a fab house to say they're building a board in accordance with
the 6012, even if it's a class-2 fab...

-Steve Gregory-


> Hi All,
> Aren't there per job microsection requirements in 6012 ?  If so, I'd call
> that an adder.
>
> Regards,
> Mark Hargreaves
>
>         -----Original Message-----
>         From:   Steve Gregory [SMTP:[log in to unmask]]
>         Sent:   Monday, September 15, 2003 11:11 AM
>         To:     [log in to unmask]
>         Subject:        [TN] Building Fabs to IPC-6012 spec's...
>
>         Hi All!
>
>         Just a general question; how much of a cost adder would be incurred
> building
>         Class-2 fabs that comply with all the IPC-6012 specifications?
>
>         Thanks!
>
>         -Steve Gregory-
>


---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------