Mime-Version: |
1.0 |
Sender: |
|
X-To: |
|
Date: |
Tue, 22 Sep 1998 10:15:07 -0700 |
Reply-To: |
|
Subject: |
|
From: |
|
In-Reply-To: |
|
Content-Type: |
text/plain; charset="us-ascii" |
Parts/Attachments: |
|
|
We have similar boards and we bake them at 125C for 12 to 14 hours in a
nitrogen inerted oven. This has solved our delamination problems with
polyimide.
Not what you wanted to hear I'm sure but hope this helps.
At 10:30 AM 9/22/98 -0400, you wrote:
>Dear Ann,
>
>(Oops, wrong advice column...)
>
>Dear Technet:
>
>We assembly an 8 layer polyimide SMT board (approximately 6" x 11" x .062
>thick). Our standard bake cycle for these boards prior to assembly has been
>250 F for 6 hours. We recently ran into a rash of delamination after reflow.
>A board vendor recommended we bake at 275 F for 16 hours. We feel that
this is
>excessive, and that our bake cycle should be adequate. What do you think?
>
>Thanks for your assistance,
>Over-baked in NY
Ken Bloomquist
Sr. Principal Process Engineer
PRIMEX Aerospace Company
P.O. Box 97009
Redmond, WA 98073-9709
Northcon/98, Show Director
<www.northcon.com>
Electronics Manufacturers Association (EMA), Secretary
<www.ema-wa.org>
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|