 
| Content-Transfer-Encoding: |
7bit |
| Sender: |
|
| Subject: |
|
| From: |
|
| Date: |
Mon, 12 Oct 1998 07:41:20 -0400 |
| Content-Type: |
text/plain; charset="us-ascii" |
| MIME-Version: |
1.0 |
| Reply-To: |
|
| Parts/Attachments: |
|
|
Good morning!
Does anyone have experience with EMI/RF shields ("cans") that have SMT
legs which you put onto pads on the board and then reflow? Can you
reflow this while reflowing the parts underneath the shield, or will
those parts see insufficient heat to reflow their solder? Do you
recommend a one-piece shield or a two piece one - where there is a
fence-like perimeter that solders onto the board with those SMT legs and
then a lid which snaps onto the fence?
Thanks in advance for the help.
-Steve
Steven K. Lustig
Process Engineer
EMS Technologies, Inc.
Norcross, GA
(770) 263-9200 x4714
[log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|
