We are a PCB manufacturer and are currently dealing with the "PITTING"
problem. Small holes, craters in the electrolitic copper.
Is there any acceptability guideline corresponding this problem. I did
not find it in the IPC-A-600.
Thanks for your help
Lorenz Gwerder
[log in to unmask] <mailto:[log in to unmask]>
www.photochemie.ch <http://www.photochemie.ch>
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################