In a message dated 96-12-11 13:12:37 EST, you write:

<<   I would like to find out what type of connector is required to
 mate with the edge connect fingers of IPC SIR test coupons.  I would
 like to use both the B36 as well as the B25A type.
 Any help would be appreciated
  >>

There will have to be two different connectors.  The B-36 has 32 contact pads
on each side, the B25A has 22.   In my system, I use an AMP connector for the
B-36 board.  The part number is 1-111212-1.  I have gotten mine most recently
from LinTech Components (516-563-3000, Denise Latkowski).  They run about $9
each, depending on quantity and are usually a long lead time (8 weeks) item.
 

As these are insulation displacing connectors, you will also need teflon
insulated ribbon cable.  My supply has been Aerospace Computer Products
(800-234-4725, Mike Townes).

I have not yet determined a suitable connector for the B-25A.

Doug Pauls
CSL

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact   *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]      *
***************************************************************************