Alan,
        We use both a Wenesco M93 Mini Wave and an AirVac 5200 system. We have had
good luck with both units. We use the Wenesco for both rework and some
production work where we cannot run through wave because of components on top
and bottom. The AirVac we use entirely for rework, mostly on BGA's. Our
biggest drawback on this unit is the cost of the nozzles. I know there are
many others out there that will do the job. These are the ones they had here
when I started and as I say, we have had very good use of these.

Wilber Heath
SCI Systems
Hooksett NH 03106

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################