Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 11 Apr 2003 15:50:55 -0700 |
Content-Type: | multipart/alternative |
Parts/Attachments: |
|
|
Thanks.
Is there a clearance from global fiducials to other geometries? I looked at
SMEMA FIDUCIAL MARK STANDARD Standard 3.1, but it doesn't say anything about
it.
-----Original Message-----
From: Cyker, Howard A (Howie) [mailto:[log in to unmask]]
Sent: Friday, April 11, 2003 2:32 PM
To: 'TechNet E-Mail Forum.'; 'Adair, Bret'
Subject: RE: [TN] Fiducial clearance
Bret,
It depends on how you're processing the board, and on what equipment.
Typically, the equipment vendor's will specify this. 5mm is often a typical
value. Some equipment manufacturers offer a 3mm option if that is required.
Howard A. Cyker
Lucent Technologies
Engineering Infrastructure - New Product Engineering
Email [log in to unmask]
Phone 978-960-2964
-----Original Message-----
From: Adair, Bret [mailto:[log in to unmask]]
Sent: Friday, April 11, 2003 5:22 PM
To: [log in to unmask]
Subject: [TN] Fiducial clearance
What clearance is recommended from a fiducial and the board edge?
Bret
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to
[log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to
[log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|