Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 29 Sep 1999 14:32:06 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Ken,
Verify the thickness as per IPC-TM-650, method number 2.1.1. This is suggested
by the IPC A-600, section 3.3.6.
Verify also IPC-6012, section 3.2.6.2 and table 3-2 (under average copper, and
minimum thin areas).
Although in the present case, it does seem like a reject.
Alain Savard, B.Sc.
CAE Electronics Ltd.
>>> Ken Patel <[log in to unmask]> 09/29/99 01:42pm >>>
If my requirement for the copper plating is 0.001" minimum (as spelled out
on my fab drawing) and if I am reading it between .0004"-.001", is it
rejects or not?. I tried to look at IPC-6012 which is calling out avg copper
thickness. I don't how easy to get ave #. This is clearly a reject to me.
But I am looking for an expert opinion on the subject. Via Hole in question
is 16 mil +3 mil / -10 mils.
re,
ken patel
______________________________________________________
Ken Patel Phone: (408) 490-6804
1708 McCarthy Blvd. Fax: (408) 490-6859
Milpitas, CA 95035 Beeper: (888) 769-1808
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text
in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################
|
|
|