Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 29 Mar 2000 16:12:56 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Technetters/Fabricators,
My supplier is having a problem with yield on our backplane (~.200",
SMOBC/HASL). It seems to be centering around
hole plugging from HASL. FHS are .024", .028", .032" for both pressfit and
pth connectors. Is this a typical problem for
these requirements??
If so, what are other finishes to consider to achieve higher yields but not
introduce large cost adders??
Comments and suggestions appreciated.
Tks........DT
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
|
|
|