Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0wHXqn-000BlBC; Wed, 16 Apr 97 11:46 CDT |
Old-Return-Path: |
|
Date: |
Wed, 16 Apr 1997 11:55:19 -0500 |
Precedence: |
list |
X-Sun-Charset: |
US-ASCII |
From [log in to unmask] Wed Apr 16 13: |
34:31 1997 |
Cc: |
|
X-Status: |
|
Status: |
O |
X-Mailing-List: |
|
TO: |
|
Return-Path: |
<TechNet-request> |
Resent-Message-ID: |
<"0DdTl2.0.T7B.a9GLp"@ipc> |
Subject: |
|
From: |
|
X-Loop: |
|
Resent-From: |
|
Resent-Sender: |
|
Message-Id: |
|
Parts/Attachments: |
|
|
Ralph,
You said:
> I also mention that a good design, where long-term reliability is a
> serious design requirement, does not have closely spaced (~1mm
> edge-to-edge) of plated-through holes on the same grid lines to where
> the reinforcement yarns bridge the spacing between holes. It is better
> to off-set the plated-through holes either diagonally or such that
> plated-through hole centers are on a grid that is greater than half of
> the sum of their hole diameters.
Does this mean that a 0.016" finished via, drilled at lets say 0.021", would have a center to center spacing of 0.060 minimum (0.039 + 0.021 = 0.060) ?
---------------------------
John Laur
Rockwell Automation
Allen-Bradley Co Inc.
1201 South Second Street
Milwaukee, WI 53204
+1 414 382 2162 (fax)
+1 414 382 2393 (phone)
[log in to unmask]
---------------------------
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|