To all,

THANK YOU VERY MUCH!!!! I guess I underestimated the good folks here on
TechNet, silly me! I am very pleased with the responses and the information.
Especially to Dave and Jay. I thought I knew the formula for figuring this
out, that is to go from an X-Y coordinate to the diameter, however I don't
think I ever heard of a factor to apply (.3535) to the diametric number to
go the opposite direction!

And I thought this would be outside the realm of TechNet! Next time I will
pay attention to the name of the forum!!

Richard Hamilton
Clemar Mfg. / Rain Bird
[log in to unmask]

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################