Hello all:

I have a PCB that I would like to try out Entek Plus on.  Problem is, the
board has tin fingers on an edge (The board gets plugged into a SIMM socket
in use).

Obviously I will need to coat those fingers somehow.  (Two sided reflow
process, no wave soldering).

Has anyone tried screen printing solder paste onto the edge fingers.  Did
you have to use a step-down stencil to control the volume?  I assume that I
am going to end up with solder bumps in the center of each of the fingers.

  

-Pat-

-------------
Patrick McGuine
Nicolet Instrument
[log in to unmask]
(608) 276-6334

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************